• FM nplus 1 transmitter devices

• Evertz Quartz Router

• SA Prisma II High Density Dual Receiver - Standard Gain

• Backup Configuration State

• Backup/Restore Failure Traps

• Maintenance Mode of inactive backup device

• Falcon ATM Adaptor

• FM active reserve device

• FM single transmitter device

• Grass Valley Large Router Layer > 1024 sources

• HMS Transponder and Power Supply (Combined view)

• Dvbt-dd Transmitter

• Merlin ATM Adaptor

• Modumax HPA Power Amplifier

• Motorola DSR-4410 Satellite Receiver Decoder

• Network GYDA Flashlink Controller / Frame

• Network Flashlink Module

• Pixtree DMBe110h Encoder

• SA D9844 Commercial Decoder

• SA D9846 Receiver Professional Decoder

• SA Digital Content Manager

• SA GS7000 HMS Fiber Node

• SA Prisma II High Density Dual Receiver

• SA Prisma II OptoStar 1310nm 1RU Forward Optical Transmitter

• Terayon CP-7600 Decoder

• Walton DP-8 De-Ice Controller

• Walton DP-9 De-Ice Controller

• Backup of D9846

• Custom extension on DCM managed device

• Support for toggling alarm suppression

• Support for the new US Daylight Savings Time rules (from 2007 on)

• HMS Transponder and Power Supply (Combined view)

• Modumax HPA Power Amplifier

• Motorola DSR-4410 Satellite Receiver Decoder

• SA D9844 Commercial Decoder

• SA Digital Content Manager

• SA GS7000 HMS Fiber Node

• SA Prisma II High Density Dual Receiver

• SA Prisma II OptoStar 1310nm 1RU Forward Optical Transmitter

• Terayon CP-7600 Decoder

• Walton DP-8 De-Ice Controller

• Walton DP-9 De-Ice Controller

• Support for toggling alarm suppression

• Support for the new US Daylight Savings Time rules (from 2007 on)

• APC 100 Antenna / Dish Controller

• Comtech UT-4505 Upconverter • DAB Dual Drive

• DAB STX

• Evertz L-Band Router • Factum Transmitter Channels

• Factum Transmitter RSW100 • Generic Quintech L-Band Router

• IDC Redundancy Switch (I/O managed – static)

• MX2001 DVBP_IP Encapsulator • Newtec NTC 2185 Universal Switching System

• Newtec NTC 2277 Sat Modulator

• Remote Sum Feed Modeled element (static)

• Specialty Microwave High Power Amplifier Switch

• Support for dual agent - single IP DOCSIS HMS Transponders

• Polling of the "backup required" status via SNMP is now supported for D9054.

• Alcatel SAM through SOAP (Static)

• Alpha BNPN Generator Control Module (Legacy)

• Alpha BNPN PDU (Legacy)

• Alpha BNPN Temperature Control Module (Legacy)

• Alpha BNPN UPS, Controller Ferro Resonant (Legacy)

• Alpha BNPN Backup Power Source (Legacy)

• DVB-T single Transmitter through Standard MIB

• Motorola SG2000 Optical Node (AM Comm Protocol)

• SA 90075 Optical Node through HMS

• SA D9054 Encoder H264 HD

• ROSA EM now has a NTP-client to synchronize the internal time with a time-server.

• When using NTP to synchronize the time, ROSA EM also provides support for daylight savings time.

• D9054 is now supported for backup.

• Modulus H264 encoder

• SA D9010 Decoder

• SA D9034 Encoder H264 SD

• SA Cetus MKII Modulator

• SA 694X Optical Node via HMS Transponder

• SA HMS 90070 Optical Node via HMS

• SA HMS 90071 Optical Node via HMS

• Generic Optical Node via HMS

• The backup system for Stellar, Stellar XT, Pyxis and Capella now also supports manual backup, linked devices, ...

• SA xDQA24 is now supported for backup

• When restoring a chain of devices, the restore can be triggered from any device in the chain now (no longer only from the root cause device)

• Encoder backup now works with other routers supported by ROSA EM

• ROSA EM software will detect disconnected clients much faster (approx. 8 seconds).

• AM 6940 BDR Optical Node (AM Comm Protocol)

• AM 6942 BDR Optical Node (AM Comm Protocol)

• AM 6942 Optical Node (AM Comm Protocol)

• AM 6944 BDR Optical Node (AM Comm Protocol)

• AM 694X Optical Node through HMS Transponder

• Backup Satellite Feed (Static)

• Channel Lineup Configuration (Static)

• Encoder Backup Configuration (Static)

• Ensemble 5030

• Evertz 500 Frame Controller

• Evertz 500AC02 SDI 2:1 Switch

• Evertz 500ADA-EQ Analog Video Distribution Amplifier with Cable Equalization

• Evertz 7700 Frame Controller

• Evertz 7703 2:1 RF Protection Switch

• Evertz 7703 RF Active Splitter

• Evertz 7707 Ethernet Fiber Transceiver

• Evertz 7707 SDI Electrical to Optical Converter

• Evertz 7707 SDI Optical to Electrical Converter

• Evertz 7707LR Fiber Receiver

• Evertz 7707LT Fiber Transmitter

• Evertz 7710 HD Cross Converter

• Evertz 7721 HD Audio DeEmbedder

• Evertz 7736 Video to SDI Converter

• Evertz 7746 Frame Synchronizer

• Grass Valley Router Controller

• Grass Valley Router Layer

• Harris Tx TCM 8600 Manager

• Harris Tx TCM 8600 Monitored Transmitter

• Motorola DSR-4400 Satellite Multiplex Decrypter (Static)

• Motorola DSR-4520x Satellite Receiver Decoder

• Probel Halo or Sirius Router

• ProtTelevision MIP Inserter (SFN adapter)

• Quintech RPS F Series Redundant Power Supply (Static)

• Quintech SRM-2150 16x16 Router

• Quintech SRM-2150 8x48 Router

• Remote Feed Device

• SA D9154 Advanced Compression Encoder

• SA D9479 GQAM

• SA D96xx multiplexer family through IIOP – limited as a trigger for backups only

• SA PRISMA II Modules: 1550 TXL EMT Transmitter (FTTH) 1 wide, FTTX Pre Amplifier, FTTX Post Amplifier

• SA Stellar XT Through SNMP

• Satellite Dish (Static)

• Sencore MRD3187 Receiver Decoder

• Signal State (Static)

• Tandberg TT1260 (Receiver/Descrambler/Decoder)

• UPS – compatible with any UPS with SNMP(v1/v2c) and RFC1628 MIB

• Wegener Unity 4600 Professional Media Receiver (Static)

• Apollo Comport Enable/Disable - Ports configured to run Apollo can now be dynamically enabled/disabled. This is a means to stop polling and get the connected RCDS devices in local control.

• IIOP communication - The main system parameters now provide a means to configure the timeout used in IIOP communications. 

• DOCSIS HMS PS - The community strings and SNMP version is now configurable. The integration now supports 2 strings of up to 5 batteries in each string. 

• AM Transponders in combination with Phoenix - It is now also possible to put alarm thresholds on the Modem Received Level.

• Apollo serial ports - It is now possible to use multiple serial ports for the Apollo functionality.

• Security transfer from ROSA - When opening the applet of the ROSA EM, it is now possible to pass an additional parameter to define the privilege level to be used.

• Copy Global can be implemented on parameter points that are stored in devices.

• 6275 Demodulator device graphic is now 1U high.

• Titan MKII voltage measurements have been removed from the parameters table.

• Clearing the encoder configuration will now blank the backup priorities. This allows reprogramming when a new configuration is applied.

• AM Transponders in combination with Phoenix now supports negative values for the Modem Received Level.

• DSN protocol for QPSK Modulator/Demodulator has been made more robust against bad command responses.

• D96xx integration via IIOP correctly generates the “outgoing stuffing rate too high” on a D96xx with QPSK card. Added tolerance when having a connection loss towards D96xx.  

• Vikinx protocol - Added more tolerance and correct handling of spurious communication problems.

• Alarm severity change - Changing the severity of an alarm will trigger making this change persistent.

• Apollo interfacing - Fix in the communication between ROSA EM (RCDS) and Apollo to handle the return codes of commands properly. If the device returns no data in reply to the command, ROSA EM will no longer consider this to be an error.

• Backup manager - Fix for race-condition in the backup manager when powering down/up an entire rack (encoders, D96xx and ROSA EM).

Back to Top of Page

• New devtype: adcltx750-tx7

• rs7000dd2 - Rhode & Schwarz Dual Driver 2 Transmitter through NetCCU

• p215txsb - Prisma-II 1550nm EM Optical Transmitter (Gap Bridger) Corrected alarm limits

• p2cpoasingler2 - Prisma-II CPOA Single Pump Amplifier (Post Amp) Changes to make input power limits settable

• A/B protection Switching enhancement on ADC DV6000 DX, MX, and DAP modules

• DV6016RPS - Added operation mode fields on ADC DV6000 Repeater Shelf

• Trap Sending - When changing the Trap Threshold it was possible to have situations where certain traps were not sent. The trap generation is reviewed completely and should work correctly now. 

• Notification System fixes - TNCS Code base didn’t correctly manage the Master TNCS situation that needed to notify for the sub managed TNCS/ROSA EM systems.

• Orbitor is now galaxy module - The orbitor was lacking a proper slot point. This is fixed now, so that it can be visualized in any position of the galaxy chassis.

• TitanMKII - The BER minor and and major high limit where swapped, in order to be correct now.

• TNCS Code base didn’t correctly reference other servers when blanks appeared in the server list. This is now fixed. The bug had influence on Notes, graphics and timed events server referencing.

• VikinX Timeout handling - The timeout system is revised to also cope with larger routers.

• Performance logging from Rosa cannot be done on Prisma II through SNMP managed devices, using the p2snmpmod devtype.

• Online Add using ROSA EM Web GUI: Port Combox doesn't properly let you select a different port with the mouse. Work around: use the arrow keys to select a different communication port. Alternative: install a higher Java Runtime Environment. e.g. 1.4.2. Do note that the PEGASUS GUI is not compatible with JRE versions higher than 1.3.1

Back to Top of Page

Back to Top of Page

Back to Top of Page